-
Are you looking for a coupon code to buy my software? You can get one from lots of 3rd party sites but they won't work. My software never goes on sale and has never been discounted. The only coupon codes that are given is when I give a club presentation and I offer a discount to the attendees. Other than that, everyone pays the same price.
Ken Sherwin's latest activity
-
Ken Sherwin replied to the thread How to increase wall thickness of 1 ring.I export both my Segment Pro and Wood Turner Pro results to Excel so I can sort on different columns for different steps in the process... -
Ken Sherwin replied to the thread Amount of wood needed..That's why they call it "The Vortex". It's just like a marriage. It's not the initial cost that's expensive. It's the upkeep!
-
Ken Sherwin replied to the thread Gaps between rings.I use my lathe as my glue press, holding each ring in a chuck with Cole jaws on the tailstock. Gently grip this ring as this chuck only...
-
Ken Sherwin replied to the thread Amount of wood needed..I considered using my bandsaw to cut the segment ends but decided the cut was too rough for a good glue joint so I never actually tried...
-
Ken Sherwin replied to the thread Amount of wood needed..I tried the cutlist method but always had several pieces of wood left that were just barely too small to use but too big to toss. I...
-
Ken Sherwin replied to the thread how do i separate a box top in the software?.The smart-alec answer is to just not glue that ring on both sides. I'll see myself out now.
-
Ken Sherwin replied to the thread Gaps between rings.If you have to put weights on the rung to close the gaps, either the glue was not spread evenly or the ring was not actually flat...
-
Ken Sherwin replied to the thread Gaps between rings.I flatten both sides of every ring before I start my glueup so that I don't have to wait for the glue to completely cure between rings...
-
Ken Sherwin replied to the thread Gaps between rings.If the vessel is either still mounted or can be remounted on the lathe, I would contemplate using a point tool or skew to carve a V...
-
Ken Sherwin replied to the thread Quick question.Your question seems to be about the inside diameter of a ring or row. (Every ring is a row but not every row is a ring, to be cleared...
-
Ken Sherwin replied to the thread Sled - Wedgie ?.Second question first. The sides of each fence arm are absolutely, strictly parallel, right? Therefore the angle from one side of...
-
Ken Sherwin replied to the thread Question about WTP.Got it. Thank you.
-
Ken Sherwin replied to the thread Question about WTP.So vertical spacers go between the segments in a ring and thus increases effective SEL and the outside diameter? What happens with an...
-
Having used Segment Pro successfully for several years, I now discover a need for some features of WTP. While most of it is...
-
Ken Sherwin replied to the thread Off Center.That's what I was doing wrong.